SKY899
Installation Manual
009-11900-001
Installation Checkout - Page 3-5
Revision F
July 18, 2013
b.
Select Type from the menu. The Equipment type menu will appear, select source equipment from
list (i.e., GPS, BarAlt, etc.). If connected to an ARINC-429 super bus, select all the other
equipment(s) that are located on that bus. When finished selecting equipment press exit.
c.
Rx channel menu will appear, select speed from the menu. The ARINC 429 receiver speed menu
will appear, select correct speed.
d.
The ARINC 429 Rcvrs menu will appear, verify receiver channels match desired wiring interface.
e.
Repeat above steps a thru d for each receiver channel input that is connected.
f.
Select exit to return to Setup Menu.
6.
From the Setup menu, select Avionics Equipment:
a.
The Equipment menu will appear, select Browse All Avionics. (See paragraph 4.4.1.5.)
b.
The system will step you through each equipment sub-menu. As you select the equipment the
next equipment menu in the loop will appear. Once you have stepped through all sub-menus, the
equipment menu will reappear.
c.
Verify the equipment shown in parentheses under each equipment title matches the wiring
interface. To change equipment source, highlight and select it from the menu.
d.
Select exit until you return to Service Menu.
e.
The Save or Revert menu will appear upon exiting setup menu. Select Save Changes to keep
current configuration. (Selecting Revert to Old Settings will cause system to exit the service
menu without saving changes.)
7.
To verify changes made to the configuration module, turn the SKY899 OFF and then enter the
Service Menu (see paragraph 4.4) and repeat Step 6.
8.
Perform system setup verification and operation procedure in paragraph 3.3.2.
3.3.1.2 Download System Configuration (via Compact Flash Card)
1.
With the SKY899 OFF, lift the memory card door on the front of the TRC899 and insert the compact
flash card into J12 connector. Carefully align the arrow from the flash card with the arrow on the
front of the TRC899 while inserting (see figure 4-40).
2.
Enter the Service Menu (see paragraph 4.4), select Configuration Management.
3.
At the Configuration Management menu, select Retrieve from CF. Verify the "download was
successful" message is displayed. If an error occurs during download, the configuration setup must be
done manually (see above "System Configuration" procedure).
4.
Turn off the SKY899 and remove the compact flash card from J12 memory card connector.
5.
Perform the system setup verification and operation procedure below (see paragraph 3.3.2) to verify
configuration data was downloaded correctly.
The document reference is online, please check the correspondence between the online documentation and the printed version.
