15
FILTRATION
The spa is factory programmed to filter two times a day for 1 hour. In most cases, this is sufficient
filtration. However, the cycle duration can be modified between 1 and 8 hours in increments of 1 hour.
The first cycle begins 6 minutes after the initial start-up of the spa, and the second cycle is 12 hours
later. To change the filtration cycle duration, press the
Temp
key, then the
Jets
key. The display will
show the default setting,
F1
. Press the
Temp
key to adjust the duration. The sequence will repeat after
cycling through 1 to 8. Once the desired filtration cycle duration is displayed, press the
Jets
key to
accept the selection and exit the program.
PROGRAM MODES
Mode is changed by pressing the
Temp
key, then the
Light
key. The default setting is in Standard
mode. The spa is factory equipped with three program modes: Standard, Economy, and Sleep modes.
Standard mode
maintains the set temperature. The equipment control pack checks the water
temperature twice per hour and heats accordingly. It will not allow the water temperature to reach below
20°F (10°C).
St
will be displayed momentarily when switched into Standard mode.
Economy mode
heats the spa to the set temperature only during the filter cycles.
Ec
will be displayed
momentarily when switched into Economy mode.
Ec
will also be displayed when the water temperature
is not current, and will alternate with water temperature when the pump is running.
Sleep mode
heats the spa to within 20°F (10°C) of the set temperature only during filter cycles.
SL
will
be displayed momentarily when switched into Sleep mode.
SL
will also be displayed when the water
temperature is not current, and will alternate with water temperature when the pump is running.
FEATURE OPERATIONS
AIR CONTROL VALVES
Your spa may be equipped with air controls. The air control is an on/off valve that allows air to be
introduced into a specific jet configuration resulting in a more vigorous jet action. Turn the valve handle
clockwise to turn the air on, and counterclockwise to turn the air off. Opening the valve increases jet
pressure and closing the valve decreases the jet pressure.
