Rigging procedures
If the array is intended to be an SB18/Kara mixed array, place a full Kara ight-case at the rigging location and remove
the lid. Direct the front face of the 3-Kara array towards the audience. In the following, the array will be designated as
ARRAY#1 and the enclosures as KARA#1 to KARA#3 from top to bottom.
For clarity purposes, the procedure is continued with an array composed of two SB18 enclosures.
11.
Check the inter-enclosure connections in ARRAY#1 (repeat for each side):
a) For both front rigging points, verify that the front arm is open and locked to 2 Kara by 2 R-BLP inserted in yellow
link holes.
b) For both rear rigging points, verify that the angle arm cursor is aligned with the 0° angle value and locked to
2 Kara by 2 R-BLP, the upper one inserted in a yellow link hole and the bottom one inserted into angle hole
0°/2°/4°.
12.
On KARA#1, take the 4 arms out as follows (repeat for each side):
a) Remove the front top R-BLP from storage position, rotate the front arm up, slide it down, and secure by reinserting
the R-BLP into the yellow link hole.
b) Remove the rear top R-BLP, slide the angle arm so as to align the cursor with the 5° angle value, and secure by re-
inserting the R-BLP into angle hole 1°/3°/5°/7.5°/10°.
It is recommended to select the 5° angle on the Kara intended to be linked to the M-BUMP. In that way the
KARA#1 axis will be parallel to the M-BUMP.
a.
b.
Kara owner's manual (EN) version 1.0
73
