Rigging procedures
6.
Set ARRAY#1 for transport as follows:
a) On each side of KARA#1, remove the front top link R-BLP, slide the front arm up, rotate down, and secure by re-
inserting the R-BLP into the top storage hole.
b) On each side of the KARA#1, remove the rear top angle R-BLP, slide the angle arm so as to align the cursor with
the storage position, and secure by re-inserting the R-BLP into the top storage hole.
c) Put the ight-case lid on.
7.
Set the M-BUMP for transport by re-inserting the 4 R-BLP into their storage locations.
For clarity purposes, the procedure is continued with an array composed of four SB18 enclosures.
8.
If not already done, remove both safety slings from the M-BUMP.
9.
Lower the array until the bottom SB18 (hereafter called SB18#4 as an example) rests on the ground and the SB18
above (hereafter called SB18#3) rests onto it.
Kara owner's manual (EN) version 1.0
77
