Rigging procedures
7.
Raise the array to the chosen height.
8.
Secure the KARA-MINIBU to the main rigging structure by using two safety slings (not included).
9.
Bring a full Kara ight-case to the rigging location and remove the lid. Direct the front face of the Kara array towards
the audience. In the following, the array will be designated as ARRAY#1 and the enclosures as KARA#1 to KARA#3
from top to bottom.
10.
Check the inter-enclosure attachments in ARRAY#1 as follows (repeat on both sides of the array):
a) Verify that each front arm (x2) is open and secured to the
link
holes of two Kara by two R-BLP.
A
link
hole is indicated by a yellow circle.
b) Verify that each angle arm (x2) has the cursor aligned with angle label 0° and is secured to two Kara by two R-
BLP, the top one being inserted into the
link
hole and the bottom one into angle hole 0°/2°/4°.
Kara owner's manual (EN) version 1.0
83
