KARA
i
®
MODULAR WST
®
SYSTEM
RIGGING PROCEDURES
VERSION 1.1
KARA
i
_RM_EN_1-1
w w w . l - a c o u s t i c s . c o m
14
6.
Repeat steps 4 and 5 until all KARAi enclosures composing the array are assembled.
7.
Secure the fixation points on the bottom KARAi as follows (repeat on both sides of the enclosure):
a.
Drive a 35 mm Torx
®
screw into the front bottom hole (T30 bit, 5 N.m/45 in.lb
f
).
b.
Drive a 55 mm Torx
®
screw into the rear bottom hole (T30 bit, 5 N.m/45 in.lb
f
).
c.
Fully drive the three remaining Torx
®
screws (T30 bit, 5 N.m/45 in.lb
f
).
Figure 9: Example of KARAi standalone array
b.
Bottom
KARAi
c.
c.
c.
a.
Summary of Contents for KARAi
Page 1: ...KARAi rigging manual EN ...