SB18
SB18
SB18
SB18
m
SUBWOOFER
SUBWOOFER
SUBWOOFER
SUBWOOFER
rigging manual
rigging manual
rigging manual
rigging manual
VERSION 1.0
SB18
m
_RM_EN_1-0
w w w . l - a c o u s t i c s . c o m
8
8
8
8
3.2
Flying
Never implement a bridled suspension on the WIFOBUMP frame.
Always use 1 motor per pick-up point.
Truss clamping
By installing a CLAMP250 instead of a shackle, an array can be attached to a truss. Refer to PROCEDURE
B
.
Final check before flying the system
Coupling bars: All lugs of locking tabs must be secured, as indicated in PROCEDURE
A
.
Shackles : All safety pins must be secured as indicated in PROCEDURE
B
.
Choose the flying option before rigging the system
Identify the appropriate flying option and rigging hole(s) by modeling the system in SOUNDVISION.
Vertical
Place the first enclosure (logo down)
Place and lock a second SB18m on top of the first one (logo down)
Refer to PROCEDURE
A
to lock the SB18MRIG bars
Remove the coupling bars from their storage location
Place and lock the WIFOBUMP
frame to the top enclosure
Refer to SOUNDVISION for the frame position (front or rear)
Refer to PROCEDURE
A
to lock the SB18MRIG bars
Attach a bow shackle Ø12mm or a CLAMP250 on the WIFOBUMP frame
Refer to PROCEDURE
B
Slightly raise the array until its bottom is at waist height
Bring the next enclosure (logo down)
Lower the array until its bottom rests on the next enclosure
Remove the bars from their storage location and slide them into adjacent rigging rails
Slightly raise the array and lock the coupling bars
Refer to PROCEDURE
A
to lock the SB18MRIG bars
To add more enclosures, repeat the previous 5 steps until the array is completed
