KUDO
®
MULTI-MODE WST
®
SYSTEM
Rigging Procedures
VERSION 1.0
KUDO_RM_ML_1.0
w w w . l - a c o u s t i c s . c o m
16 en
2.
Lower the system so as to land the bottom enclosure on its dolly board, attach both BLP.
3.
Remove both rear angle selection BLP on the bottom enclosure (both rear inter-enclosure BLP remain attached).
Figure 18: Removing both rear angle selection BLP
4.
Repeat steps 1 through 3 until the entire system is landed.
5.
Detach the motor hooks.
6.
Take down the KBUMP by removing its 4 BLP and placing them into the 4 inner storage holes.
When removing the BLP support KBUMP in order to prevent it from falling.
7.
For each KUDO
®
enclosure, remove all remaining BLP.
8.
On both sides of each KUDO
®
enclosure:
a.
Push the rotating arm into the captive
position.
b.
Arrange the front rigging point by
pushing the rigging tab inwards so that it
is flush with the enclosure.
c.
Place the 2 BLP in their storage
locations (the rotating arm will be
locked).
Figure 19: Preparing a KUDO
®
enclosure for transportation
a.
b.
c.
!
WARNING