HEATER BASE
LOCK WASHER
BOLT
NUT, CAGE
LEG
AXLE
SPACER
WHEEL
RETAINING CAP
HUB CAP
SLIDING HANDLE
HANDLE
BRACKET
SNAP BUTTON
ALIGNED WITH
RETAINING HOLES
RETAINING HOLES
1. Tip the heater back on the end access door so the
louvered air intake panel is facing up.
2. Locate the axle, two wheels, retaining cap, and two
nylon spacers in the heater’s accessory package.
3. Install a retaining cap onto one end of axle. Slide one
wheel onto axle until it stops up against retaining cap.
Ensure that hub cap slots of the wheel are facing
towards retaining cap. Slide spacer onto axle until it
stops up against side of wheel opposite retaining cap.
4. Slide axle through holes in case assembly until
spacer butts up against case. See Fig. 2.
5. Slide remaining spacer and wheel onto other end of
axle rod. Slots in wheel face are pointed toward end
of shaft.
6. Install other retaining cap.
7. Snap hub caps onto wheels.
FIG. 2
WHEEL ASSEMBLY
Premier 170
1. Align the support leg channel to the four cage nuts on
underside of base.
2. Mount the support using four 1/2 in. bolts and
lockwashers. Tighten securely.
FIG. 3
The Premier 170 is equipped with sliding handles for
convenient “wheel-barrow” style mobility. Sliding handles
are pre-assembled and installed on the heater case. For
shipping purposes, the handles are turned from the
required operating position.
1. Remove the sliding handles by grasping the free end
and pulling the handle completely out of the handle
bracket.
2. Align the snap button on the end of the handle with
the retaining hole in the handle bracket.
3. Insert the end of the handle into the handle bracket
and depress the snap-button.
4. Slide in the handle and depress the snap-button as
necessary until the handle is locked in the fully
retracted position.
FIG. 1
SLIDING HANDLE ASSEMBLY
Premier 170
9
LEG ASSEMBLY
Premier 170
Summary of Contents for Premier TS170
Page 2: ......
