Attention!
After extended opera-
tion, this model may leave carbon
dust or other debris around the
track. This dust and debris can
stain carpet and other materials.
Consider this when setting up
your layout. Ernst Paul Lehmann
Patentwerk and LGB of America
are not liable for any damages.
SERVICE
Do-It-Yourself Service Levels
Level
- Beginner
Level
- Intermediate
Level
- Advanced
Attention!
Improper service will
void your warranty. For quality
service, contact your authorized
retailer or an LGB factory service
station (see
Authorized Service
).
Hint
: Additional expert instruc-
tions for many LGB products are
available at www.lgb.com.
Lubrication
The axle bearings and the side
rod ends should be lubricated
occasionally with a small amount
of LGB Maintenance Oil (50019).
Cleaning
This model can be cleaned exter-
nally using a mild detergent and
gentle stream of water. Do not
immerse this model.
Replacing the light bulbs
Lanterns:
Pull the lantern hous-
ing away from the model. Pull the
socket out of the housing. Pull the
plug-in bulb out of the socket.
Plug in a new bulb. Reassemble.
Replacing the smoke
generator
- Pull the safety cover out of the
smoke stack (Fig. 5).
- Use pliers or tweezers to pull the
old smoke generator out of the
stack (Fig. 6).
- Cut the wires to the old genera-
tor and attach them to the
replacement generator (Fig. 7).
- Insulate the connections and
push the replacement generator
into the stack.
- Reassemble.
Replacing the traction tire
- Remove the hex screw on the
drive wheel with the traction tire.
- Remove the side rods.
-
Use a small, straight-blade
screwdriver to replace the trac-
tion tire:
- Pry the old traction tire out of the
wheel groove.
- Gently insert the new traction
tire into the wheel groove.
- Make sure that the traction tire is
seated properly in the wheel
groove.
- Reassemble.
Maintenance parts
50010 Smoke and Cleaning
Fluid
50019 Maintenance Oil
51020 Gear Lubricant
62204 Standard Motor with
Long Shaft
63120 Brushes, Assembled,
14 mm and 16 mm,
8 pieces
63218 Standard Pick-Up
Shoes, 2 pieces
65853 Smoke Generator, 5V
68511 Plug-In Bulb, Clear, 5 V,
10 pieces
69184 Traction Tires, 46.5 mm,
10 pieces
I
NSTRUCTIONS FOR
ADVANCED USERS
MTS Onboard Decoder
Programming functions
You can program numerous func-
tions of the onboard decoder to
suit your requirements. If you
want to do this, program the
“function values” in “registers”
(CVs) using a PC and the 55045
MTS PC Decoder Programming
Module. You can also program the
function values using a 55015
Universal Remote.
Hints:
- For normal operation, it is not
necessary to change the func-
tion values.
- If programming results in unsat-
isfactory operation, you can
reprogram the factory pre-set
values of most important CVs:
Program register CV55 to func-
11
