REV5
For any questions please contact us at toll free (877) 482-2040 Mon-Fri 8 a.m. to 4:30 p.m. 17
135lb Stainless Steel Spreader Installation
4.5
TEST
Connect the Negative (black) Battery Cable before testing. Refer to section 5 for Operating
Instructions.
4.5.1 Vibrator
Verify the electrical connections have been made properly.
Turn on the Vibrator. Listen for vibration.
Turn off the Vibrator.
4.5.2 Speed Control Unit
Verify the electrical connections have been made properly.
Press the top right button to start the spinner.
Press the top left button to turn off the spinner.
4.5.3 Plow Clearance
Move the lift cylinder lower pin to the upper hole in the A-Frame then, check for clearance
between the plow and the Directional Control after each step. The plow should have clearance
when the Directional Control is open at its minimum and maximum positions (See Section
5.2.2). Refer to the Snowrator Owner’s Manual for instructions on moving the plow.
Raise the plow to its maximum upward position.
Adjust the plow all the way to the left.
Adjust the plow all the way to the right.
Return the plow to the center position.