REV5
For any questions please contact us at toll free (877) 482-2040 Mon-Fri 8 a.m. to 4:30 p.m. 27
135lb Stainless Steel Spreader Installation
Troubleshooting Cont…
First two lights on controller are
flashing
1. Spinner disk is stuck
2. Spinner Shaft is bent
3. Spinner disk is dragging on
material deflector
1. Turn controller off.
Disconnect spinner motor and
free the spinner. Reconnect
spinner Motor. Turn Controller
on again to reset.
2. Turn controller off.
Disconnect spinner motor and
inspect shaft for damage,
replace if necessary. Reconnect
spinner Motor. Turn controller
on again to reset.
3. Turn controller off.
Disconnect spinner motor and
clean off material deflector.
Reconnect spinner Motor. Turn
controller on again to reset.
First three lights on controller
are flashing
1. A short circuit between the
controller and the spinner
motor
2. Motor has an internal short
circuit.
1. Turn controller off. Check,
repair, or replace the wiring
between the controller and
spinner motor. Turn controller
on again to reset.
2. Turn controller off. Replace
the spinner motor. Turn
controller on again to reset.
First four lights on controller are
flashing
1. Spinner motor not connected
2. Bad connection between
controller and spinner motor
3. Power connector and Motor
connector connected to
Power/Ground harness
1. Turn controller off. Connect
spinner motor. Turn controller
on again to reset.
2. Turn controller off. Clean
connection between controller
and spinner motor. Turn
controller on again to reset.
3. Disconnect the Motor
connector from the
Power/Ground harness and
connect it to the Spinner Motor.
Turn controller off and then on
to reset.
First five lights on controller are
flashing
1. Low battery voltage
1. Increase Engine RPM. Turn
controller off then on again to
reset.
2. Turn Pump, Lights, Vibrator
and Spinner motor off, Increase
Engine RPM and let run for a
while, Check volt meter when
volt meter is approximately
12V. Turn controller off then on
again to reset.