Front Panel Controls and Features
1.
LEVEL
controls adjust signal levels for channels A and B.
2.
Status
LEDS indicate the following:
·
SIGNAL
indicates a signal is present and sound should be heard from the
Speakers providing the level controls have been turned up.
·
CLIP
indicates that maximum output power has been reached. Increasing
the level control or input signal will not increase the output power.
·
PROTECT
indicates at the point of switching the amplifier on for a few seconds. Once they
have turned off the amplifier is ready for normal operation. If at any stage, they stay
illuminated, a fault has occurred. See section under PROTECT LEDs for more information.
·
BRIDGE
indicates the amplifier is in BRIDGE mode
·
RESET
3.
POWER
switch.
4.
FAN
ventilation holes.
Do Not Obstruct.
Rear Panel Controls and Features
1.
There are two
INPUT CONNECTORS
per channel. One is a combination 3 pin XLR and 3 pole
(TRS) ¼" jack socket, the other a male XLR for linking to other amplifiers. Both balanced and
unbalanced signals can be used to drive the amplifier.
