BPA10T30W100
Broadband System User Manual
E-Mail: sales@l2microwave.com
www.l2microwave.com
- 10 -
•
Use personal protective equipment in the event of smoke formation. Use breathing protection in the danger
zone that is independent of the ambient air
.
2.2.9.
Rules for amplifier services
Do not operate the amplifier system (equipment) unless the case is closed
.
Risks when reconnecting the power supply
Do not reconnect the power supply until the amplifier is fully installed. Failure to observe this may result in
electric shock or RF radiation
.
•
Ensure that all case components are securely installed
.
•
Ensure that all cables and grounding lines are properly connected
.
2.3.
Operator (Personnel/User)
Risk of injury from insufficient qualification of personnel
All work (operation, maintenance, troubleshooting, repair, etc.) should be performed only by qualified
personnel. Failure to do so may result in serious injury or property damage.
2.4.
Safety Devices
2.4.1.
Protective Covers
Risk of injury due to removed protective covers
This symbol indicates a protective cover for electrical circuits at risk due to large amounts of energy,
RF current or supply voltage. The protective cover prevents unintentional contact with these electrical circuits.
•
Pay attention to the cover marked with this symbol
.
•
Do not remove the protective cover with this symbol
.
•
Any work that requires accessing the inside of the system may be carried out by the manufacturer's service
personnel only
.
2.4.2.
Instructions for Protection against Electrostatic Discharge (ESD)
Risk of damage to electronic components
To avoid damage to electronic components, all work on the equipment and components must be performed
in a location protected against electrostatic discharge (ESD). The following items can be used individually or in
combination to protect against electrostatic discharge
.
•
Protective armband with grounding cable
•
Wearing antistatic shoes and antistatic clothes
