p. 87
5.11.3
Atmos
This page is selectable from the
tab suite and allows you to set various
atmospheric conditions.
Cruise Layer
Wind Dir/Spd
Allows you to set the wind direction/speed.
Altitude
Allows you to set the altitude AMSL.
Turbulence
Allows you to select cobblestone or rough air turbulence
conditions.
NOTE:
Conditions are mutually exclusive.
Icing
Allows you to select icing conditions.
Jet Upset
Allows you to select special wind effects at the aircraft.
Intermediate Layer
Wind Dir/Spd
Allows you to set the wind direction/speed.
Altitude
Allows you to set the altitude AMSL.
Turbulence
Allows you to select cobblestone or rough air turbulence
conditions.
NOTE:
Conditions are mutually exclusive.
Icing
Allows you to select icing conditions.
Surface Layer
Wind Dir/Spd
Allows you to set the wind direction/speed.
Gusting To
Allows introduction of pseudo-random gusts. A surface wind of at
least 10 knots must be active for this function to be selectable.
Turbulence
Allows you to select cobblestone or rough air turbulence
conditions.
NOTE:
Conditions are mutually exclusive.
Icing
Allows you to select icing conditions.
Temperature
Field Temperature Allows you to set the Field Temp.
Lapse Rate
Allows you to set the Lapse rate.
Tropopause
Altitude (AMSL)
Allows you to set the height of the tropopause level.
Pressure
QNH
Allows you to set the QNH value.
QFE
Allows you to set the QFE value.
Temperature Inversion
Lower Altitude
Allows you to set lower altitude level.
Upper Altitude
Allows you to set upper altitude level.
Inversion Lapse
Rate
Allows you to set the inversion lapse rate.
Activate Inversion
Select to enter the selections into the simulation.