MPM-1000A Operator Manual
1000-7075 Rev E
9-3
Figure 9-3 NCW Network Tab
Table 9-1 NCW Network Tab
Control/Indicator/Function
Description
Node Name
Displays the Node name assigned to the Terminal. Node name can be
changed from the NCW Setup page.
Status
Displays the connect status of the Terminal.
Role
Indicates the current Terminal role (NM or NC).
Terminal Type
Indicates that the Terminal can be a net controller or a net member only.
Terminal Type can be changed from the
Configure
→ Network Centric
Waveform Setup
→ Parameters
.
Connect Button
Click the Connect Button to join or establish a network.
Disconnect Button
Click the Disconnect Button to log out of a connected network. Valid if the
Terminal is connected as a network member. The Terminal will continue
to track the network time-base and NC signaling.
Terminate Button
Click the Terminate Button to stop all network activity.
Network Terminal List
A list of the active nodes in a network. It is only valid and/or populated
when this
Terminal is “connected” to the network. The IP address listed in
this list is the IP address of the data port at that Terminal. The Handover
number, if present, indicates the order in which that node will take over
the network if the current network controller terminates.
Data IP Address
Displays the IP address assigned to the data Ethernet port (J1).
Satellite Information
Satellite
This combo box enables the selection of a previously configured Satellite.
Terminal Home Beam
This is the Satellite beam that this terminal has been assigned to transmit
and receive in.
Apply button
Pressing the Apply button updates the system with the new Satellite and
home beam.
