MPM-1000A Operator Manual
1000-7075 Rev D
6-14
Figure 6-14 IP Address Configuration Screen
d. Click
Save
.
e. A pop-up window will appear, select
NO
to keep the HCI at the default address.
(See Figure 6-15)
Figure 6-15 Change HCI to Modem Address
f. Turn off the Modem; this will be the Master Modem of the stack.
6.4.4 Configure Slave Modem
a. Connect the Slave Modem to the network switch.
b. Turn on the Slave Modem, wait until Modem Status LED has turned green.
c. Set Slave Modem in Maintenance Mode. See Section 6.4.2
d. Select
Modem Tab.
(See Figure 6-16 Configure Modem Screen)
e. Set
Frequency Reference
to
10MHz External
. The System will show alarms and
HW
status box will go red once the external frequency reference is selected.
(See Figure 6-16)
