MPM-1000A Operator Manual
1000-7075 Rev E
11-3
Table 11-1 MIL-STD-188-165A Configure Parameters
Item
Description
Satellite In Use
Select Satellite to use.
BW Seg In Use
BW Segment of the Satellite to use.
Modulator (TX):
Modulation
Select waveform modulation.
Data Rate
Specify data rate (bps).
FEC
Select forward error correction.
Diff Coding
Select differential coding.
Scrambling
Select scrambling type.
RS (Outer Code)
Select Reed Solomon.
IF Freq (MHz)
Specify Modem TX IF frequency in MHz.
Modulation Mapping
Select modulation mapping.
Data Inversion
Select transmit data inversion “On” or “Off”.
Data Clock
Select transmit data clock.
Flow Control
Select transmit data flow control.
Demodulator (RX):
Modulation
Select waveform modulation.
Data Rate
Specify data rate (bps).
FEC
Select forward error correction.
Diff Coding
Select differential coding.
Scrambling
Select scrambling type.
RS (Outer Code)
Select Reed Solomon Coding.
IF Freq (MHz)
Specify Modem RX IF frequency in MHz.
Modulation Mapping
Select Demodulator Demapping.
Data Inversion
Select receive data inversion “On” or “Off”.
Apply
button
Apply the changes made in the Satellite, modulator and demodulator fields.
TX Power
Sets the Modem‟s 70 MHz IF power level and enables or disables the
transmitter. Increment or decrement the power level using the up and down
level buttons.
NOTE
Left click: changes by 0.1
Right click: changes by 1.0
These changes take effect immediately (i.e. clicking the Apply button
is not required).
