KeyRF – PC Remote Control
L3 Systems
9
5/19/2007
[A] Transmitter Address
The address set in the KeyRF receiver has to match the
address in the transmitter. The factory receiver setting is
COOOOOOO
, where “C” signifies where a jumper is installed, and
“O” where a jumper is NOT installed
If “A” is pressed in response to the initial setup prompt, the
following prompt will appear:
Address: [C0000000]:
If you respond with only an <ENTER>, then it will keep the
current setting. Make sure you type 8 O’s or C’s.
To change the transmitter address, remove the small cover,
prying with a fingernail or a small screwdriver (like ones used
for eyeglasses). Orient the transmitter with key chain hole at
the bottom. Place jumper in a position that matches the “C”
in the address loaded into the receiver.
Changing Transmitter Battery
Both transmitters has a 12-volt A23 type battery. Make sure
that battery plus (+) terminal matches diagram on bottom of
case.
