35
INSTALLATION
Check the appliance is electrically safe when you have finished.
4-Wire Conduit Installation
Disconnect the supplied power cord from the terminal block
and ground post. Keep the terminal block parts; you will need
them. Remove the strain relief clamp from the power cord
and remove the power cord and strain relief clamp from the
mounting bracket (
).
The range is shipped with reducer plates to give a 1 1/8’’
diameter opening for conduit connection (
). Find the
reducer plates (
) in the conversion kit and fit them to
the mounting bracket.
Fit a squeeze connector (not supplied with the range), to your
conduit. Insert the conduit through the reducer plates on the
mounting bracket. Allow enough slack to easily attach the
wires to the terminal block.
NOTE: Do not install the conduit without a squeeze
connector.
Fit the wires to the ground post and terminal block (
)
NOTE: Make sure the wires are completely inserted into
the terminals and secure connections are made.
Secure the squeeze connector in place in the bracket by
tightening the squeeze connector screws.
Refit the electrical connection cover.
Seal the Openings
Seal any openings in the wall behind the range and in the
floor under the range when hookups are completed.
When all Connections are Completed
MAKE SURE THE FLOW OF COMBUSTION AND
VENTILATION AIR TO THE RANGE IS UNOBSTRUCTED.
Fig. 11.11
Fig. 11.12
Black
Red
White: Neutral
Ground wire
