U
S
A
&
C
ANADA
Fuel conversion
M
AINTENANCE
3
3
2
1
a
2
1
open top broiler
Orifice for gas oven
The orifice for open top broiler or gas oven are always replaced in the following sequence:
1.
Screw the adjusting cone (2) and insert it into the mixing tube in order to free sufficient space
for unscrewing the orifice.
2.
Unscrew the orifice (1) with a 7 mm flat wrench for the stone grill or no. 17 for the oven..
3.
Install the orifice (1) corresponding to the new type of gas and tighten it.
4.
Ignite the burner and adjust the air inlet by screwing or unscrewing the adjusting cone (2) until
you obtain a slightly blue flame showing no separation; separation of the flame is an indication that
there is too much air.
5.
Then lock the adjusting cone (2) with the locking washer (3).
Back of the cooker
Front of the cooker
Orifice
Orifice
Access is gained to the oven orifice either from the back of the cooker or from the front by removing the
drawer. It is easier to change the orifice by accessing it from the rear.
Once you have changed the orifices, it is a good idea to adjust the low settings for the hob burners (see
Section 1).
Once the appliance has been adapted to a different type of gas or to a pressure other than those for
which it was previously set, the new settings will have to be indicated in place of the previous settings,
and a new gas information label will be supplied with the new orifices.
Any sealing will must be done again.
Save the orifices removed from the appliance for future use.
Page
64
Installation Guide Château G4 - USA Canada
LA CORNUE
08NOTINSG4/ULC-1
Summary of Contents for Chateau 120
Page 73: ......
