INSTALLATION GUIDE FOR
“C
HÂTEAU
” RANGE
- G4
08NOTINSTALG4/EN - 3
76
C
E
A
D
B
G
F
The electronic control system ensures total safety when there is a defective flame or ignition failure.
In operation, the system is locked if the flame goes out. The safety time for the oven burner is 10 s
maximum and must be no more than 60 s (should the system fail, the solenoid valve cuts the gas off in 10
s maximum).
Note:
The red indicator in the bottom part of the control box indicates any operational defects related to oven
ignition. If this indicator is ON, check that the gas shutoff valve is set to the open position and the cooker
is well supplied with gas, then press the button (G) to the left of the indicator light. Before using the oven
for the first time or if it has not been used for a long period of time, you have to press this button several
times to defuse any trapped air from the gas circuit.
If this phenomenon persists, contact our after-sales department or your dealer.
RCC disc: Radiation, Convection, Conduction
Your oven is fitted with an RCC enamelled cast iron disc which transmits the heat
from the gas burner to the oven by Radiation, Convection or Conduction.
Thanks
to this heat distribution and transmission system your oven is perfectly adapted to
all types of cooking, including simmering.
Before using your gas oven, install the burner and RCC disc, making sure that the
studs are correctly positioned in the corresponding holes.
N.B.: If you want to remove the RCC disc after cooking (e.g. for cleaning), allow it to cool down
completely.
Ignition of the gas oven:
For all your cooking, please use your drip tray in the bottom position except when cooking at low
temperatures.
To operate your oven, first press button (A), which switches on the oven.
The
light in the oven comes on if the oven door is open. The light goes out
automatically when the door is closed.
The simmerstat (C) switches on the heating element on the vault of the oven
(grill), and the thermostat (B) switches on the gas burner.
The simmerstat and the thermostat are coupled to ON indicator lights (E and D).
As soon as you turn the thermostat or simmerstat the corresponding indicator light
comes on.
To ignite the gas burner, turn the oven thermostat (B) to the desired temperature.
In addition to indicator light (D), the burner ON light (F) also comes on.
The burner ON light (F) remains lit if the gas burner is operating and goes out if
the burner stops. The oven ignition takes places automatically as follows:
-
the ignition electronics are switched on (by the thermostat),
-
starting of sparkling igniter (sparks are emitted),
-
opening the gas electrovalve,
-
ignition of burner,
