45
Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
Free from the bottom tag.
When replacing the cover fi rst locate it on the
bottom tag second locate the two side tags and
then replace the screws.
4-Wire Conduit Installation
Disconnect the supplied power cord from the
terminal block and ground post. Keep the terminal
block parts; you will need them. Remove the strain
relief clamp from the power cord and remove
the power cord and strain relief clamp from the
mounting bracket.
The range is shipped with reducer plates to give a
1 1/8’’ diameter opening for conduit connection.
Find the reducer plates in the conversion kit and fi x
them to the mounting bracket.
Attach a squeeze connector (not supplied with the
range), to your conduit. Insert the conduit through
the reducer plates on the mounting bracket. Allow
enough slack to easily attach the wires to the
terminal block.
NOTE: Do not install the conduit without a squeeze
connector.
Attach the wires to the ground post and terminal
block
NOTE: Make sure the wires are completely inserted
into the terminals and secure connections are
made.
Secure the squeeze connector in place in the
bracket by tightening the squeeze connector
screws.
Replace the electrical connection cover.
Installing a 3-Wire Power Cord
Disconnect the supplied power cord from the
terminal block and ground post. Keep the terminal
block parts; you will need them. Remove the strain
relief clamp from the power cord and remove
the power cord and strain relief clamp from the
mounting bracket. Discard the strain relief clamp.
NOTE: Do not install the power cord without a
strain relief - use the clamp supplied with the
cord.
Install the new strain relief device to the mounting
bracket by removing the two clamping screws,
feeding the two halves (ears fi rst) through the hole
in the mounting bracket and loosely replacing the