7
Forestière
SECTION FOR USERS
Ignition. Loading
Using a liquid detergent with ammonia, remove the protective varnish covering the
appliance's cast-iron top.
The stove should be first used
at very low heat for several hours
. On the other hand,
if the chimney, having not been used for some time, is cold and damp, you may have
draught problems. It is therefore recommended that you burn wood in the appliance to
warm up and dry out the chimney and initiate the draught.
If, after several days and despite these precautions, the appliance still does not work pro-
perty with the appropriate fuel, call in a specialist to check the installation.
For coal
, remove the round hatch using the tongs.
In the case of use with wood, you will need to remove the front and rear firebox plates
(see page 6) which will enable 50 cm logs to be inserted into the firebox. These plates will
be reinserted when using coal.
SECTION FOR USERS
1. B
EFORE INITIAL IGNITION
2. I
NITIAL IGNITION
3. L
OADING THE FIREBOX
Place letter B
of the round hatch (for wood),
C (for coal) opposite the arrow located on the
fire plate.
For wood
, remove the fire plate using the
tongs.
