Setup
1. Install 2-AA batteries into the TX141TH-Bv2 sensor.
The red LED light will blink when transmitting.
2. Insert 3-AA batteries into the back of the station.
4. Keep sensor and weather station within 5 feet for at least 15
minutes after installing batteries. This allows the sensor and station
to sync properly and ensures a strong connection.
5. After 15 minutes, place sensor in desired location (position
sensor
).
6. Program the station in the settings menu.
Button Function Explanation
For better programming instructions, please note these terms for
button use:
•
Press:
Press and release the designated button.
•
Hold:
Hold the button for 3 seconds then release the button.
308-1417
www.lacrossetechnology.com/support
Page | 2
PRESSURE
AA
AA
LED
TX
button
Note:
Press the TX button inside the battery cover of the sensor to
force a signal transmission.
AA
AA
AA