Page | 3
327-1417BW
Wind Speed Weather Station
Wind Speed sensor
TX141Wv2
Setup Preparation
Items you will need to setup your station (not included):
1. Phillips head screwdriver for assembly.
2. Fresh Batteries:
3 (three) AA alkaline batteries for the station
2 (two) C alkaline or lithium batteries for the Wind sensor.
For best results:
• Remove weather station and sensor from the package and place together on a table
or bench, within easy reach.
• Place batteries and screwdriver within reach of setup location.
• Keep sensor and weather station within 5-10 feet for at least 15 minutes after
installing batteries. This allows the sensors and station to sync properly and ensures a
strong connection.
Quick Setup
1. Power up: Insert 2-C batteries into the Wind/TH sensor. Then, insert 3-AA batteries
into the weather station.
2. Configure basic settings. Set Time, Date etc.
3. After 15 minutes, place sensor outside (see mounting instructions on
page 14
).
Note:
Batteries are
not included
Weather Station
327-1417BW
C
C
Red LED on sensor:
The sensor has a red LED light that flashes once during each
sensor signal transmission.
AA
AA
AA
