La Crosse Technology, Ltd
Page 5
Activate/Deactivate Time Alarm
To activate or deactivate Alarm 1 or Alarm 2, use the slide bars on the back of
the clock.
There is a slide bar (ON/OFF) for AL 1 and for AL 2.
When active, Alarm 1 will show in the Date display with alarm icon.
When active, Alarm 2 will show in the Temperature display with alarm icon.
Snooze Alarm
When alarm sounds, press the SNOOZE/LIGHT button to silence the alarm for
5 minutes.
The alarm icon will flash.
Snooze may be repeated up to 7 times.
In snooze mode, press any button except SNOOZE/LIGHT to stop alarm for one
day.
Note: The alarm is crescendo sound. The alarm will sound for 2 minutes and
then shut off completely if no buttons are pressed.
Display Modes
The date may be displayed as the Month/Date format or as the Date/Month
format.
Press the
▲
button to select 12-hour time and the Month/Date format.
Press the
▲
button again to select 24-hour time and the Date/Month format.
Atomic Alarm Clock is blank: No letters, numbers or dashed lines
Check that the batteries are installed correctly.
may be overpowered or underpowered.
Remove batteries from alarm clock.
Press any button 20 times. Leave the batteries out of the display for 2 hours.
Insert batteries into the alarm clock.
Atomic Alarm Clock drains batteries quickly
Test a new set of alkaline batteries. Write down the date of installation and the
voltage of the batteries.
When the batteries fail, please note the date and voltage again. This is helpful in
determining the problem.
Check for leaking batteries, which may damage the alarm clock.
Atomic Alarm Clock has missing segments
Explanation: When parts of numbers, letters, or pictures are missing on the
display, it is often power related.
With all power removed, the alarm clock should be blank.
If numbers still appear, please check for scratch guard.
Power:
Check that the batteries are installed correctly.
