La Crosse Technology, Ltd.
Page 4
The highly integrated IC chip supports worldwide AM band reception from 520 to
1710 kHz using a digital low-IF architecture with a minimum number of external
components and no manual alignment required. This digital low-IF architecture
allows for high-precision filtering offering excellent selectivity and SNR with
minimum variation across the AM band.
1.
With the radio ON press and release the MODE button to select AM radio.
2.
Press and release the left TUNE button to decrease the frequency and the right TUNE
button to increase the frequency of the selected band.
FM Radio:
The FM receiver is based on the proven FM tuner. The receiver uses a digital low-IF
architecture allowing the elimination of external components and factory
adjustments. The IC chip integrates a low noise amplifier (LNA) supporting the
worldwide FM broadcast band (64 to 108 MHz).
1.
With the radio ON press and release the MODE button to select FM radio.
2.
Press and release the left TUNE button to decrease the frequency and the right TUNE
button to increase the frequency of the selected band.
White LED Light
ON: Press and release the LIGHT button to turn on the white LED light.
OFF: Press and release the LIGHT button again to turn the light off.
Note: There is a light shadow above and below the light beam, which is normal
for a three LED arrangement.
Reset Radio
If the display is blank, charge the battery then press the RESET button once.
The RESET button is a small pinhole near the antenna, where the crank handle
rests.
Antenna
Fully extend and rotate the telescoping Antenna and place near a window to receive a
steady strong signal and avoid a broken or noisy reception.
Optional Earphones (not included)
Plug in a set of 3.5mm earphones (not included) into the 3.5mm earphone jack
to privately listen to the radio
.
