Position Rain Sensor
LTV-R1 Rain Sensor
Lets identify the parts of the rain sensor.
Base
Funnel
Release Tabs
Funnel
Rocker
Battery
Release Tabs
Alignment Tab:
An extra piece of plastic used for repositioning the battery
compartment correctly. After batteries are installed, make sure this alignment tab is
facing the front of the Base to lock all four Battery Release Tabs back into place.
Alignment Tab
Important:
Remove
the twist tie from
below the rocker. The
twist tie secured the
rocker for shipment
• Mount your rain sensor in an open area for a more accurate rain count.
• Placing the rain sensor on the ground provides the most accurate rainfall measurement as there is no
wind shear. Unfortunately, since insects think of rain sensors as personal hotels, placing the sensor 3-6
feet above ground may deter the insects.
• This is a self-emptying sensor, but be sure your unit is not sitting in a depression that would prevent
rain from draining out of the bottom
• Your rain sensor should be accessible to allow for periodic cleaning of leaves or other debris that may
clog the funnel.
• Install the Rain sensor on a level platform that is stationary and has a direct line of sight to your station.
• Insert mounting screws through the holes in the base of the rain sensor. Do not over tighten.
• Avoid other wireless rain sensors as this can cause inaccuracy due to signal interference.
• The maximum wireless transmission range to the rain station is over 330 feet (100 meters) in open air,
not including walls or floors.
• For video instruction, please visit:
