La Crosse Technology LTV-R2 Quick Start Manual Download

Page: 1 / 4

Model: LTV-R2

DC: 090517

Rain Sensor

Insert 2- AA batteries into the rain sensor according to polarity.

1. Flip open both locking tabs on your rain sensor and lift off the funnel portion.

2. Pull up on the battery cover and remove.

3. Install 2-AA batteries according to polarity. Reposition the battery cover over the battery compartment,

and firmly push down to lock it back into place

5. Remove cardboard and any tape around the rocker before use. These were used to protect the

sensor from unwanted movement during shipping.

6. Place the funnel portion back over the sensor and re-secure the locking tabs.

Power

Funnel

Battery Cover

Locking Tab

Remove piece under

rocker of rain sensor

Summary of Contents for LTV-R2

Page 1: ...A batteries according to polarity Reposition the battery cover over the battery compartment and firmly push down to lock it back into place 5 Remove cardboard and any tape around the rocker before use...

Page 2: ...sensor should be accessible to allow for periodic cleaning of leaves or other debris that may clog the funnel Install the Rain sensor on a level platform that is stationary and has a direct line of si...

Page 3: ...select Devices under Add Edit 3 On Edit Devices page select ADD DEVICE 4 Scan Device ID Scan the bar code on your sensor or press inside the Device ID search box to enter your code manually Once enter...

Page 4: ...s subject to the following two conditions 1 This device may not cause harmful interference and 2 This device must accept any interference received including interference that may cause undesired opera...