CARE & MAINTENANCE
Battery replacement instruction:
When batteries of different brand or type are used together, or new and old batteries
are used together, some batteries may be over-discharged due to a difference of
voltage or capacity. This can result in venting, leakage, and rupture and may cause
personal injury.
• Always purchase the correct size and grade of battery suitable for the intended use.
• Always replace the whole set of batteries at one time, taking care not to mix old and
new ones, or batteries of different types.
• Clean the battery contacts and those of the device prior to battery installation.
• Ensure the batteries are installed correctly with regard to polarity (+ and -).
• Remove batteries from product during periods of non-use. Battery leakage can cause
corrosion and damage to this product.
• Remove used batteries promptly.
• For recycling and disposal of batteries, and to protect the environment please check
the internet or your local phone directory for local recycling centers and / or follow
local government regulations.
THERMOMETER / HYGROMETER
POWER UP
1. Insert 1 fresh AA alkaline battery, according to polarity, into the
snug Battery Compartment.
2. Rotate the Time Set Wheel to set the time.
3. Mount on a wall and enjoy!
Note:
The quartz movement
will keep the clock running
accurately. If the clock does not
operate, or steadily loses time,
replace the battery.
Time Set
Wheel
Battery
Compartment
AA
Learn more from our video:
bit.ly/wallclock_setup
MOVEMENT COVER
1. OPEN:
Turn the cover counterclockwise until the head is aligned
with the arrow. Then lift the cover off the clock.
2. CLOSE:
Place the cover in the open position. Then turn it clock
wise until the head is back on top, directly under the hanger hole.
MOUNTING
Indoor:
Mount the clock on a wall using the hanging hole on the back.
Outdoor:
Choose a location with an overhang to protect the clock from
the overhead sun or standing snow or rain. A shaded location will
prevent inaccurate temperature readings. Mount the clock on a wall
using the hanging hole on the back.
CLOSE
OPEN
OPEN
CLOSE
OPEN
CLOSE
• Your thermometer and hygrometer have been pre-calibrated and
should not need adjustment.
• Before manually adjusting your sensors, allow the clock to sit for at
least 2 hours in the same location.
• To manually adjust your sensors, gently turn the temperature or
humidity sensor adjustment on the back of the clock until desired
setting is reached.
