19
a.
With a nonabrasive solution, clean and dry the back
of the mounting bracket and the mounting surface to
ensure a secure hold. The mounting surface should
be smooth and flat.
b.
Remove the protective strip from one side of the tape.
c.
Adhere the tape to the designated area on the back of
the mounting bracket.
d.
Remove the protective strip from the other side of the
tape.
e.
Position the remote temperature sensor in the desired
location, ensuring that the Wireless Weather Station
can receive the signal.
Note: Mounting with adhesive tape is not recommended as a permanent
mounting solution. Only use the adhesive tape during set-up process.
B.
Mounting the WS-7394U-IT
Wireless Weather Station
The
Wireless Weather Station
can be mounted in two ways:
•
with the table stand
•
on the wall with the use of a wall hanging screw (not included)
1.
USING THE TABLE STAND
The indoor weather station comes with the table stand
already mounted. If you wish to use the table-stand all
that is required is to place the indoor weather station in an
appropriate location.
2.
WALL MOUNTING
a.
Remove the table-stand. To do this, pull down on the
stand from the rear and rotate forward.
b.
Fix a screw (not included) into the desired wall,
leaving approximately 3/16 of an inch (5mm)
extended from the wall.
c.
Place the indoor weather station onto the screw using
the hanging hole on the backside.
d.
Gently pull the indoor weather station down to lock
the screw into place.
Maintenance and Care Instructions
A.
Extreme temperatures, vibration, and shock should be avoided to
prevent damage to the units.
B.
Clean displays and units with a soft, damp cloth. Do not use solvents
or scouring agents; they may mark the displays and casings.
C.
Do not submerge in water.
