02
Initial Setup
BASICS
Power Up
Note:
It may take up to 10 minutes for the sensor data to appear on your display.
Thermo-Hygro Sensor
Slide the battery cover down to remove it. Install 2 fresh “AA” batteries according to polarity and snap
the cover back into place. The blue LED light will flash when transmitting.
Glide Pro Sensor
Slide the outer cover down to remove it. Then remove the inner battery cover and install 3 fresh “AA”
batteries according to polarity. Replace both the battery cover and outer cover.
Display
Insert the 5V Power Adapter into an outlet, and then plug it into the Power Jack on the bottom of
the display. Next, remove the Insulation Tab from the Battery Compartment. About 30 seconds after
powering on, it will automatically enter the Settings Menu. See page
06
for more details.
Power Jack
Glide Pro Sensor (LTV-W3)
Back of Display (V23)
Thermo-Hygro Sensor
(LTV-TH2i)
