24 |
P a g e
Complete a Tip Test:
Write down the Total Rain reading or reset the Rain Total to 0.00. With rain sensor mounted
slowly pour water into the funnel to tip the rocker of the rain sensor 10 times. Wait at least 2
minutes for all the rain to collect. Repeat three times.
•
Compare these tests. If they are the same, then your rain is reading correctly. If the rain
readings are different, repeat the test 3 times to avoid human error. Then look for causes
such as mounting too tight or debris clogging the funnel.
RAIN HIGH: WHY IS MY RAINFALL READING HIGH?
•
Check for sources of RF (radio frequency) interference such as other wireless rain sensors,
ham radios or electric transformers.
•
Keep the station six feet from cordless phones or wireless routers etc.
Complete a Tip Test:
Write down the Total Rain reading or reset the Rain Total to 0.00. With rain sensor mounted
slowly pour water into the funnel to tip the rocker of the rain sensor 10 times. Wait at least 2
minutes for all the rain to collect. Repeat three times.
•
Compare these tests. If they still read high then contact support.
HOW CAN I CLEAN THE RAIN SENSOR?
1.
Remove rain funnel (open locking tabs on both sides and pull off funnel)
2.
Gently remove debris or insects inside the rain sensor.
3.
Clear debris from drain vents.
4.
Clear debris from the rain funnel.
5.
Reinstall the rain funnel.
Note: Do not oil the rain sensor.
WHY ARE THE SENSOR READINGS ON MY STATION DIFFERENT FROM THE
SENSOR READINGS IN THE APP?
•
The reading on your station is the “real time” reading. Your station updates as soon as it
receives a new reading from the sensor.
•
The App updates data every 60-90 seconds.
•
Since Wind Speed changes frequently, this is the common difference you may notice
between your station and your app.
