6 |
P a g e
•
Place your sensor in a well-vented area. Trapped moisture will cause inaccurate readings.
•
Maximum transmission distance from your Thermo-Hygro sensor to your station, in open air
is 400 feet (121.92meters).
•
Insert the mounting screw through the front of the transmitter and into the wall. Tighten the
screw to snug (do not over tighten).
•
General Thermo-Hygro sensor mounting video:
http://bit.ly/TH_SensorMounting
WHERE TO I PLACE MY STATION?
Your station is designed for flexible placement on a desk or countertop, or to position on the
wall. When the stand is closed, it provides wall mounting holes.
•
Position within reach of an outlet that is always active. Some outlets in living rooms and in
bedrooms may only be active when the light switch is on.
•
This station must operate with the 5 volt power cord in order to receive sensor updates
and/or to update Wi-Fi data when connected. Operation on battery power will only maintain
time/date settings if you need to move your station.
•
Best reception occurs when only one wall is between your station and each sensor outside.
•
Position you station six feet from other electronics and wireless devices. If you suspect RF
(radio frequency) interference, simply move your weather station a few feet.
WHAT IS DISTANCE | RESISTANCE | INTERFERENCE?
Distance:
•
The maximum transmitting range in open air is over 400 feet (121.92 meters) between each
sensor and your station.
•
Consider the signal path from your station to each sensor as a straight line.
•
Consider the distance the station is from other electronics in the home.
Resistance:
•
Each obstacle: walls, windows, vegetation, stucco, concrete, and large metal objects will
reduce the effective signal range by about one-half.
•
Mounting your sensors on a metal fence can significantly reduce the effective signal range.
Interference:
•
Consider electronics in the signal path between the sensors and your station.
•
Simple relocation of the sensors or the station may correct an interference issue.
•
Windows can reflect the radio signal.
•
Metal will absorb the RF (radio frequency) signal.
•
Stucco held to the wall by a metal mesh will cause interference.
•
Transmitting antennas from: ham radios, emergency dispatch centers, airports, military
bases, etc. may cause interference.
•
Electrical wires, utilities, cables, etc. may create interference if too close.
