La Crosse Technology, Ltd
Page 2
This atomic wall clock offers seven time zones:
The atomic wall clock works in North America. Outside of North America, the atomic wall clock
will not receive a WWVB signal, but will keep time like a quartz clock.
Atomic Wall clock Factory Restart
Explanation:
The factory restart returns the atomic wall clock
to an “out-of-the-box” state and
often resolves an issue.
Factory Restart:
1. Remove all power from the wall clock.
2. Press one of the buttons on the wall clock at least 20 times to clear all memory.
3. Verify that the wall clock is blank
4.
Leave without power for 15 minutes
(very important).
5. Insert fresh batteries into the wall clock.
6. Do not press buttons for 5 minutes.
Fahrenheit/Celsius
Press and release the
SET °F/°C
button to switch the temperature display from Fahrenheit
to Celsius.
Inaccurate Indoor Temperature Reading
Batteries
may be overpowered or underpowered. Remove power from the wall clock.
Press any button 20 times. Leave the wall clock unpowered for 1-2 hours.
Install fresh Alkaline batteries with correct polarity.
If the indoor temperature is, still contact support with the indoor temperature reading and the
reading of the comparative product.
Does the clock have a backlight?
No the wall clock does not have a backlight.
Time is off by hours
Check to see if the
WWVB
Tower icon appears on the atomic wall clock. If not, the atomic
wall clock has not received a WWVB time signal in the past 24 hours.
Reposition the atomic wall clock with the front or back facing Colorado.
Check that the
Time Zone
selected correctly reflects your location. Adjust the time zone in
the
Program Menu.
Check that the DST indicator is correct for your location (most areas observe DST so this
should be ON). Adjust the DST indicator in the
Program Menu.
Large buildings, metal roofed buildings and buildings or rooms full of electrical and/or radio
equipment make it difficult to receive the WWVB time signal.
Daylight Saving Time
