Short-form instructions for commissioning the
Wireless Weather Station WS 2510
A functional test of the complete weather station should be carried out before the individual sensors are fitted in their final
location. For this purpose, it is practical to set up all the sensors near to the base station, although, in doing so, a minimum
distance of 6 feet must be maintained.
Step 1
Commissioning the wireless temperature/humidity sensor by inserting
a round bar magnet into the opening in the housing.
Step 2
Activating the wireless wind sensor by inserting the associated round bar
magnet.
Step 3
To commission the wireless rain sensor, the housing must first be opened.
The housing is placed on a flat surface with the funnel opening downwards.
Turning the base plate in a clockwise direction will unlock it and enable it
to be removed.
Step 4
The round bar magnet for commissioning the wireless rain sensor must
be pushed into the latching holder on the electronic box (located in the top
half of the now seperated rain sensor). The correct polarity is marked in
red on the latching holder. The housing is closed by aligning the top and
bottom half so that the magnet on the rocker is facing the electronic
box. Locking is achieved by turning the base plate in a counter-clockwise
direction until it clicks into place.
