37
RAIN SENSOR
•
100% solar-powered with built-in rechargeable alkaline
power cell
•
High-efficient solar panels maintain operation throughout
all seasons
•
Self-emptying bucket
•
Transmission range: about 100 meters (Open field, free of
obstructions).
SETTING UP:
IMPORTANT:
Make sure to observe the correct polarity when inserting batteries. The
"+" markings on the batteries must line up with the diagrams inside the battery
compartments.
Inserting the batteries incorrectly may result in permanent damage
to the units.
During the setup process, place the wireless display and the outdoor
sensors on a surface with 1-3 meters
between the sensors and the display.
Only
use
Alkaline Batteries for the Wireless Display and Thermo-hygro sensor,
rechargeable batteries may not work.
1. It is important to allow sufficient light to reach the solar
panel while activating the wind sensor. Make sure the
lights are on in the setup room and the solar panel is
facing a 60W light bulb or brighter - do not cover with
hands or other objects. Remove the black protective foil
on the solar panel and use the provided plastic reset rod
to gently press the reset button once in the hole on the
bottom of the sensor.
2.
Twists open the top of the solar rain sensor. Remove the securing tape from the
seesaw and the black protective cover from the solar panel. Swing the seesaw
once to ‘wake-up’ the rain sensor. The solar rain sensor should then be placed
under a bright environment in order to charge up the rechargeable batteries.
IMPORTANT:
Completely reset the rain sensor:
a. Unscrew the battery cover on bottom of the rain sensor and remove the
rechargeable batteries
b. Completely cover the solar panel to
block any light source
c. Wait 20s, then re-insert the 2 x AA
rechargeable batteries and re-screw the
battery compartment back
d. Wait 2s, and uncover the solar panel
e. Swing the seesaw once and put the rain
cover top back.
f. Place the solar rain senor under bright
environment to charge-up the rechargeable
batteries.
Unscrew Battery
Cover on Bottom on
the Rain Sensor
Cover
completely the
Solar Panel
Seesaw
Top view
Press Reset Button on Bottom
of the Wind Sensor (Solar
Panel Must Face Light)
