4
DETAILED SET-UP GUIDE
I.
BATTERY INSTALLATION
Batteries will fit tightly. To avoid start-up problems, make sure that the
batteries do not spring free.
A.
REMOTE THERMO-HYGRO SENSOR
1.
Pull the cylindrical rain cover off the sensor.
2.
Remove the battery cover (located on the backside of the sensor,
above the mounting post and bracket). Press the arrow and slide
the battery cover off.
3.
Observing the correct polarity install 2 AA batteries.
4.
Replace battery cover, and place rain cover snugly onto the sensor.
B.
RAINFALL SENSOR
1.
Remove the flat-head screw and battery cover, located on the
underside of the base.
2.
Observe the correct
polarity, and install two AA
batteries.
3.
Make sure the rubber
weather seal is in place and
replace the battery cover
and screw.
Battery
Cover
Mounting
Bracket/Receptor
Rain
Cover
Thermo-Hygro
Sensor
Battery
Compartment
