La Crosse Technology WS-7220U-IT, Instruction Manua

9

B.  MOUNTING WITH ADHESIVE TAPE 
Note: 

The adhesive tape is not intended to be used as a permanent 

mounting solution.  Only use the adhesive tape while you are 
positioning the Weather Station and thermo-hygro sensor. 

1)  With a nonabrasive solution, clean and dry the back of the 

mounting bracket and the mounting surface to ensure a secure 
hold.  The mounting surface should be smooth and flat. 

2)  Remove the protective strip from one side of the tape. 
3)  Adhere the tape to the designated area on the back of the 

mounting bracket. 

4)  Remove the protective strip from the other side of the tape. 
5)  Position the remote thermo-hygro sensor in the desired location, 

ensuring that the Weather Station can receive the signal. 

B. WIRELESS WEATHER STATION

1. The Wireless Weather Station comes with the table stand 

attached to the back of the Receiver.  If you wish to use the 
table-stand, simply place the Wireless Weather Station in an 
appropriate location, and pull out on the attached stand. 

2. To wall mount, push the table stand flat against the Wireless 

Weather Station (if it isn’t already flat).  Fix a screw (not 
included) into the desired wall, and place the Wireless Weather 
Station onto the screw using the hanging hole on the backside.  
Gently pull the Wireless Weather Station down to lock the screw 
into place. 

 
 
TROUBLESHOOTING  
NOTE: For problems not solved, please contact La Crosse Technology via e-mail or 
phone, or visit our website, www.lacrossetechnology.com 

Problem:

 The LCD is faint 

Solution:

 Replace batteries 

Problem: 

No outdoor temperature is displayed. 

Solution:

1)  Bring any units from outside, inside and place the units 3 to 5 feet apart with 

nothing in-between them. 

2)  Remove the batteries from all units. 
3)  Press one of the buttons on the Wireless Weather Station display at least 20 

times to clear all memory.  Verify that the display is blank before proceeding. 

4)  Using good quality alkaline batteries, place the batteries back into the outdoor 

temperature sensor; making sure they are installed according to the diagrams in 
the battery compartment.