La Crosse Technology, Ltd.
Page 9
The Forecast station is powered by 2-“C” alkaline batteries.
Manually Set Time/Date: Program Menu
PROGRAM MENU: The SET button moves through the program menu. When you
press and release the SET button after each step, you will move to the next
step. The OUT/+ button will change a value.
CONTRAST: Hold the SET button for five seconds. LCD 4 will flash. To increase
or decrease the Contrast of the LCD display, press and release the OUT/+
button. Press and release the SET button once to move to the time zone.
TIME ZONE: The Time Zone will flash, showing a number following by the letter
h. Use the OUT/+ buttons to change the Time Zone. Please note North American
Time Zones are Negative Numbers: -4h Atlantic, -5h Eastern,-6h Central, -7h
Mountain, -8h Pacific, -9h Alaskan and -10h Hawaiian. The dash preceding the
Time Zone number must show for North America. Press and release the SET
button to move to DST setting.
DAYLIGHT SAVING TIME: DST will show and ON will flash. Most states use DST,
so this should be set to ON. However if your location does not use DST, use the
OUT/+ button to turn it OFF. Press and release the SET button once to select
radio-controlled time.
RADIO-CONTROLLED TIME: RCC will show and ON will flash. Use the OUT/+
button to set the RCC signal. (Leave this ON to receive WWVB signal) Press and
release the SET button once to select 12/24-hour time.
12/24-HOUR TIME MODE: Either 12h or 24h will flash. Use OUT/+ button to
change from 12 to 24 hour format time (12h for AM/PM, 24h for military time).
Press and release the SET button once to select hour.
HOUR: The Hour will flash. Use the OUT/+ button to set the Hour. If using 12-
hour Time Mode, be sure to check the hour for am or pm. Press and release the
SET button once to move to minutes.
MINUTES: The Minutes will flash. Use the OUT/+ button to set the minutes.
Press and release the SET button once to select the year.
YEAR: The Year will flash. Use the OUT/+ button to set the Year. Press and
release the SET button once to select the month.
MONTH: The Month will flash. Use the OUT/+ button to set the Month. Press
and release the SET button once to select the date.
DATE: The numeric day will flash. Use the OUT/+ button to set the Date
correctly. Press and release the SET button once to select Fahrenheit or Celsius.
FAHRENHEIT OR CELSIUS: A degree symbol will flash, followed by F or C. Use
the OUT/+ button to change to your preference. Press and release the SET
button once.
AIR PRESSURE UNITS: The barometric air pressure units will now flash. Press
and release the OUT/+ button to select inHg (inches of Mercury) or hPa
(hectopascal or milibars).Press and release the SET button once to set pressure
numbers.
RELATIVE AIR PRESSURE: The Relative Barometric Air Pressure number setting
will flash 29.92 inHg or 1012.8 hPA (default settings).Press and release the
OUT/+ button to increase the setting or the IN button to decrease the setting.
Press and release the SET button once to set forecast sensitivity.
FORECAST SENSITIVITY: Two tendency arrows will appear and a flashing
number (2, 3, or 4) will appear under the forecast icon. Press and release the
OUT/+ button to select the desired Forecast Sensitivity setting. The lowest
