DETAILED SET-UP GUIDE
BATTERY INSTALLATION
A.
REMOTE TEMPERATURE SENSOR
1. Remove the mounting bracket. The bracket snaps on and off easily.
2. Remove the battery cover, by sliding the cover down.
3. Observing the correct polarity install 2 AA batteries. The batteries will fit
tightly (to avoid start-up problems make sure they do not spring free).
4. Replace the battery cover by sliding upwards. Be sure battery cover is on
securely.
B.
INDOOR WEATHER STATION
1. Remove the battery cover. To do this, insert
a solid object in the space provided at the
lower-central position of the battery cover,
then push up and pull out on the battery
cover.
2. Observe
the
correct
polarity, and install 3
AA batteries.
3. Replace the battery cover.
Note:
Immediately after the batteries have been
installed, the LCD (Liquid Crystal Display) will
flash. Within 15 seconds the indoor t
indoor relative humidity, and the weather icons
(sun and clouds) will be displayed. If no
remove batteries for 10 seconds and reinst
the outdoor temperature is not displayed within
four minutes, remove batteries from both units, wait 30 seconds, and reinstall making sure to
install batteries into the remote temperature sensor first. The time will show 12:00 and start
searching for the WWVB signal. If it successfully receives the time signal (usually at night), it
will display the correct time (default time-zone is Eastern). You will need to adjust the time zone
to match your local time.
emperature,
t,
all. If
5
