2
•
LCD contrast selectable
•
Low battery indicator
•
EL
back-light
•
Display in 3 languages selectable: English, German and French
•
Wall mounting or table standing
The Remote Temperature/Humidity Sensor
•
Remote transmission of outdoor temperature and humidity to weather station by 433 MHz
signal
•
Weather
resistant
casing
•
Wall
mounting
case
•
Mounting at a sheltered place. Avoid direct rain and sunshine
QUICK SET-UP GUIDE
Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries.
1.
Have the intelligent weather station and remote temperature/humidity sensor 3 to 5 feet
apart.
2.
Batteries should be out of both the intelligent weather station and remote
temperature/humidity sensor units for 10 minutes.
3.
Place the batteries into the
remote temperature/humidity sensor
first then into the
intelligent weather station
.
4.
DO NOT PRESS ANY BUTTONS FOR 15 MINUTES.
In this time the intelligent weather station and remote temperature/humidity sensor will start to talk to
each other and the display will show the intelligent temperature/humidity, outdoor temperature/humidity,
heat index and dew point. If the intelligent weather station does not display all information after the 15
minutes please retry the set up as stated above. After all information has been displayed for 15 minutes
you can place your sensors outdoors and set your time.
Important Notes on Set-up and Operation
•
The remote temperature/humidity sensor should be placed in a dry, shaded area.
•
Fog and mist will not harm your remote temperature/humidity sensor but direct rain must be
avoided.
•
The remote temperature/humidity sensor has a range of 330 feet. Any walls that the signal will have
to pass through will reduce distance. An outdoor wall or window can have up to 30 feet of
resistance and an interior wall can have up to 20 feet of resistance. Your distance plus resistance
should not exceed 330 ft. in a straight line.
•
The remote temperature/humidity sensor transmits a signal every minute. After the batteries have
been installed, the intelligent weather station will search for the signal for a duration of 4 minutes. If
there is no temperature or humidity reading in the OUTDOOR LCD after 4 minutes, make sure the
units are within range of each other, or repeat the battery installation procedure.
•
If a button is pressed before the intelligent weather station receives the signal from the remote
temperature/humidity sensor, you will need to follow the battery installation procedure again.
To complete the set up of your new wireless weather station after the 15 minutes have passed please
follow the steps that follow in the Detailed Set-Up Guide.
