background image

 

9

IMPORTANT: 

Transmission problems will arise if the setting for additional sensors is not followed as 
described above. Should transmission problems occur, it is necessary to remove the 
batteries from all units and start the setup again from step 1. 

 

Note:

 

Daily WWVB reception (Atomic time) is attempted at the top of each hour between 

12:00 am to 6:00 am. If the reception is successful, there is no reception attempt until the 
following day. When this is successful, the received time will override the manually set time. 
The date is also updated with the received time. (Please also refer to the notes on “WWVB 
Radio Controlled time” and “Manual Time Setting”)

 

 

WWVB RADIO CONTROLLED TIME 

The NIST (National Institute of Standards and Technology – Time and Frequency Division 
WWVB radio station is located in Ft. Collins, Colorado, and transmits the exact time signal 
continuously throughout the United States at 60 kHz. The signal can be received up to 2,000 
miles away through the internal antenna in the Wireless Weather Station. However, due to 
the nature of the Earth’s ionosphere, reception is very limited during daylight hours. The 
Wireless Weather Station will search for a signal every night when reception is best. The 
WWVB radio station receives the time data from the NIST Atomic clock in Boulder, 
Colorado. A team of atomic physicists is continually measuring every second, of every day, 
to an accuracy of ten billionths of a second per day. These physicists have created an 
international standard, measuring a second as 9.192.631.770 vibrations of a Cesium-133 
atom in a vacuum. This atomic clock regulates the WWVB transmitter.  
 

 

10 

Note:  

If the WWVB tower icon flashes on the top left of the LCD, but does not set the time 

or the tower does not appear at all, then please note the following: 

 

 

Recommended distance from any interfering sources like computer monitors or TV 
sets is a minimum of 6 feet (2 meters). 

 

With ferro-concrete rooms (basements, superstructures), the received signal is 
naturally weakened. In extreme cases, please place the unit close to a window and/ or 
point its front or back towards the Fort Collins, Colorado transmitter. 

 

During nighttime, the atmospheric disturbances are usually less severe and reception 
is possible in most cases. A single daily reception is adequate to keep the accuracy 
deviation below 1 second.

 

 

In case the Weather Station is not able to detect the WWVB-signal (disturbances, 
transmitting distance, etc.), the time can be manually set (please refer to the notes on 

Manual time setting

).

 

 

INSTALL OR REPLACE BATTERIES IN THE WEATHER STATION 

The Weather Station uses 2 x AA, IEC LR6, 1.5V batteries. To install or replace the 
batteries, please follow the steps below: 
 
1. 

Remove the cover at the back of the Weather Station. 

2. 

Insert batteries observing the correct polarity (see 
marking). 

3. Replace 

compartment 

cover. 

 

 

11 

INSTALL OR REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER 

The Temperature Transmitter uses 2 x AA, IEC LR6 and a 1.5V battery. 
To install or replace the batteries, please follow the steps below: 
1. 

Remove the battery compartment cover at the back of the 
transmitter. 

2. 

Insert the batteries, observing the correct polarity (see marking). 

3. 

Replace the battery compartment cover on the unit. 

 

Note: 

When changing batteries in any of the units, all units need to be reset 
by following the setup procedures. This is because a random security 

code is assigned by the transmitter at start-up and this code must be received and stored by 
the Weather station in the first 3 minutes of power being supplied to it. 
 

BATTERY CHANGE: 

It is recommended to replace the batteries in all units regularly to ensure optimum accuracy 
of these units (Battery life See 

Specifications

 below). 

 

 
Please participate in the preservation of the environment. Return used 
batteries to an authorized depot. 
 
 

 

 

12 

 

FUNCTION KEYS: 

 

Weather Station: 

 
 
 
 

 
 
 
 

 
SET: 

This key is used to:

 

 

Enter the set mode for the following functions: LCD contrast, Time zone, Daylight 

saving time ON/OFF, Time Reception ON/OFF, 12/24 hour display, Manual time, 
Year, Month, Date, Sunrise/ Sunset city location, Snooze time duration, °F/°C, and 
Weather forecast sensitivity settings. 

 

Toggle between the display of "W date + month", "Second", "Alarm time", 

and "Date + month + year". 

SET key

MIN/ MAX key

ALM key

 

SNOOZE/ SUN key

 

CH/ + key

 

Summary of Contents for WS-9711U-IT














Reviews: