7
changes the Daylight Saving Time dates, your La Crosse Technology clock will automatically set itself
to the correct time on the newly designated dates.
Arizona and Indiana
If you live in an area that does not recognize DST you must press the (unmarked) DST button for one
second to deactivate your clock’s DST program. To reactivate the DST program simply press the DST
button again for one second.
POSITIONING THE ANALOG CLOCK:
Before wall mounting, please check that the WWVB signal can be received from the desired location. To
wall mounting:
1.
Fix a screw (not supplied) into the desired wall, leaving the head extended out by about 3/16"
(5mm).
2.
Hang the Analog clock onto the screw. Please remember to ensure it locked on the place
before releasing.
FREQUENTLY ASKED QUESTIONS
Q. How long will the battery last?
A. A good AA alkaline battery will last over one year. If your clock is located in an area with little
interference where it can quickly receive a signal, the battery can last much longer than one year.
Q. Can the clock be wired to control timing circuits?
A. No.
Q. Why does the second hand move only once every 2 seconds?
A. When the battery drops below 1.25 volts the clock indicates that it is time to change the battery by
advancing the second hand in 2-second steps. The operating voltage range is 1.25 to 1.75 volts.
CARE AND MAINTENANCE:
•
Extreme temperatures, vibration and shock should be avoided as these may cause damage to
the units and give inaccurate forecasts and readings.
•
When cleaning, use a soft damp cloth only. Do not use solvents or scouring agents as they
may mark the casing.
•
Do not submerge the unit in water.
•
Immediately remove all low powered batteries to avoid leakage and damage. Replace only
with new batteries of the recommended size.
•
Do not make any attempts to repair the unit. Return it to its original point of purchase for repair
by a qualified engineer. Opening and tampering with the unit may invalidate its guarantee.
•
Do not expose the unit to extreme and sudden temperature changes, as this may lead to rapid
changes in forecasts and readings and thereby reduce its accuracy.
BATTERIES CHANGE:
For best performance, batteries should be replaced at least once a year to maintain the best running
accuracy. Ensure that the batteries used are new and the correct size.
Please help in the preservation of the environment and return used batteries to an
authorized depot.
WARRANTY
La Crosse Technology, Ltd provides a 1-year limited warranty on this product against
manufacturing defects in materials and workmanship.
This limited warranty begins on the original date of purchase, is valid only on products
purchased and used in North America and only to the original purchaser of this product. To
receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem
determination and service procedures. Warranty service can only be performed by a La Crosse
Technology, Ltd authorized service center. The original dated bill of sale must be presented
