9
The outdoor Thermo-hygro transmitter works with 2 x AA IEC LR6,
1.5V batteries. To install and replace the batteries, please follow
the steps below:
1.
Remove the airflow cover of the transmitter.
2.
Remove the battery compartment cover.
3.
Insert the batteries, observing the correct polarity (see the
marking in the battery compartment).
4.
Replace the battery cover and the airflow cover onto the unit.
NOTE:
When changing batteries in any of the units, all units need to be reset by following the
setting up procedures. This is because the thermo-hygro sensor at start-up assigns a
random security code and this code must be received and stored by the Weather Center in
the first several minutes of power being supplied to it.
HOW TO INSTALL AND REPLACE THE BATTERIES INTO THE WEATHER
STATION
The Weather Station works with 2 x C,
IEC LR14 1.5V batteries. When the
batteries need to be replaced, the low
battery symbol will appear on the LCD.
To install and replace the batteries,
please follow the steps below:
1.
Remove the battery compartment
cover.
2.
Insert the batteries observing the
correct polarity (see the marking in
the battery compartment).
3. Replace the battery cover.
