Model: WT-3181 www.lacrossetechnology.com/support
Page | 1
Model:
WT-3181
Instruction Manual
DC:
100114
18” Indoor/Outdoor Atomic Wall Clock
Get Started
Step 1:
Remove the round battery cover from the back of the clock.
Step 2:
Insert 1 fresh AA, LR6 1.5 volt ALKALINE battery according to
the polarity marked on the case. Replace the battery cover.
Step 2:
Firmly press the time zone button once.
Step 3:
Position the clock on an exterior wall that faces Ft. Collins,
Colorado. During the night, your clock will automatically set itself.
Note:
The hands will move to the 12:00, 4:00 or 8:00 position and
search for the radio signal. If the radio signal is received the time
will set. If the signal is
not
received the clock will stay at the
12:00, 4:00 or 8:00 position and search for the WWVB time signal
on the even hours. Once the radio signal is decoded, the hands
will automatically adjust to the correct time. This may take up to 5
nights.
Step 4:
The default time zone is Pacific Time. If the clocks sets itself and
the hours are off, hold the correct time zone button for 5 seconds
to correct.
Position Clock
Indoor:
Choose a location 6 feet or more from electronics such as
cordless phones, wireless gaming systems, televisions, microwaves,
routers, baby monitors, etc., which can prevent signal reception.
Position near an exterior wall that faces Ft. Collins, Colorado for
WWVB time signal reception.
Round
Battery
Cover
