13
“
C
ONSOLE
I
NSTRUCTIONS –
M
ANUAL
P
ROGRAM (P1)
”
“
B. SET THE DESIRED TIME or DESIRED DISTANCE
To avoid the user to select TIME and DISTANCE in the same program to confuse the user couldn’t distinguish
which one (TIME or DISTANCE) as the first priority. User could only select TIME or DISTANCE in the same program,
one at the time
If you would like to select TIME value, not DISTANCE
value:
UP
or
DOWN
button:
a. After pressing the
ENTER
button to enter into
MANUAL PROGRAM (P1)
, the
TIME
function
mode will appear with the display flashing “0:00”.
b. Use
UP
or
DOWN
buttons to set the desired
TIME
(1:00 TO 99:00; 1 MINUTE INCREMENT)
NOTE for TIME:
Count Up: If a target time was not selected,
TIME
will count up from 0:00 to maximum 99:59 minutes
Count Down: If you have set the target time, the
console will count down from that selected target
time down to 0:00
If you would like to select DISTANCE value, not TIME
value:
ENTER
button and then
UP
or
DOWN
button:
a.
After pressing the
ENTER
button to enter into
MANUAL PROGRAM (P1)
, the
TIME
function
mode will appear with the display flashing “0:00”.
b. Press
the
ENTER
button again, the
DISTANCE
function mode will then appear with the display flashing
“0.0”
c. Use
UP
or
DOWN
buttons to set the desired
DISTANCE (1 TO 999KM/MILE; 1 KM/MILE
INCREMENT)
NOTE for DISTANCE:
Count Up: If a target distance was not selected, this
would measure the total distance from 0:00 to 999
km/mile
Count Down: If you have set the target distance, the
console will count down from the selected target
time down to 0
Summary of Contents for 15 Neon II
Page 37: ...36 FRONT B A C K...
