33
“
C
ONSOLE
T
ROUBLE
S
HOOTING
G
UIDE
“
PROBLEM POSSIBLE CAUSE
SOLUTION
Verify the gap between Speed Sensor and the Magnet is 5mm or less
Verify that all the Wire Plugs are connected FIRMLY, correctly and are not
damaged
The Computer isn’t receiving a
signal from the Speed Sensor?
Verify that the sensor Magnet is installed correctly
The Sensor is faulty
Replace the Speed Sensor
The Speed
Display
Show “O”
The Computer is faulty
Replace the Computer
1.
The connection between the
Circuit Board and the LCD
Membrane is loose.
2.
Gently press down on the
LCD Screen, if the partial
display disappears, then it is
a connection problem
Verify that the Circuit Board is securely fastened to the Computer Case.
Retighten the Screws. Take care NOT to over tighten the Screws as this
may destroy the Circuit Board. You just need to keep the Circuit Board firm,
STOP tightening screw when you meet resistance
The Rubber Membranes between
the Circuit Board and the LCD
Screen is misaligned/not in a
same line. You might be able to
see that the LCD Screen is on a
slight angle and NOT inline or
parallel with the Console Cover
1.
Open the Console.
2.
Remove the Circuit Board’s Screws, gently remove the Circuit Board,
Re-align the LCD screen and the Rubber Membrane.
3.
Reassemble the Circuit Board and taking care not to bump or knock
the Rubber Membrane out of alignment before the Circuit Board
Screws are tight. You just need to keep the Circuit Board firm, STOP
tightening screws when you meet resistance
The LCD
Screen
Partially
Displays
The Computer is faulty
Replace the Computer
Summary of Contents for 15 Neon II
Page 37: ...36 FRONT B A C K...
