DEPRESS
FOR PLUG
INSTALA
TION
DEPRESS
FOR PLUG
INSTALA
TION
14).
Using the three (3) mounting screws provided by the factory, screw down the lock to the mounting plate or door.
• Make sure you do not pinch the wires, see
Figure 9
.
15).
Secure entry cable with a wire tie, making sure that any extra cable is in a safe position and cannot be damaged by any moving
parts or sharp edges, see
Figure 10
.
LA GARD recommends the torque setting of 30 inch/pounds (3.4 newton/meters) when installing the
Swingbolt™
lock.
8).
Install the cable clamp over the cable on the inside of the door
with the flat side facing the door
.
9).
Slide down to the hole to protect the cable from rubbing on the edge of the hole.
10).
Gently pull on the cable to assure that there is no excess cable in the hole that would rub on the metal door.
11).
Route the cable on the notch of the cable clamp as shown, see
Figure 7
.
12).
Press the snap connector toward the bottom of the lock.
13).
Carefully insert the entry cable plug into the lock at the “ENT” position, see
Figure 8
.
CHANGING YOUR BATTERY
1).
Remove black plastic battery compartment cover (located at the bottom of the keypad)
by gently pulling downward on its handle.
2).
Allow the battery and its attached leads to drop down and out of the battery
compartment. If it does not drop, gently pull on the battery until it drops out.
3).
The connector is easily removed by unsnapping it from the two terminals on the top of
the battery.
Never Pull on the Battery Leads
4).
Connect a new 9-Volt Alkaline battery to the battery clip.
5).
Gently push the battery and the leads completely up into the battery compartment.
6).
Install the battery cover by placing one side of the cover in position first and then gently
pressing the other side into place.
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
© copyright 2008
(P/N)
734.018
LA GARD - A Member of the Kaba Group
Page 3 of 3
